Sealprotect® XL leg cast protector

Features and Benefits

This shower cover features a sturdy plastic ring with a silicone membrane. Slip your foot through the opening, and pull the cover up to place your lower leg inside the vinyl sleeve.

Ensure the silicone seal sits above the bandage or cast and fits snugly for water-tight protection.

The cover can be reused multiple times, for up to two months. Allow to air dry between uses.

Plastic ring dimensions:

• Inner circumference: 72 cm
• Outer circumference: 80 cm
• Inner diameter: 23 cm
• Outer diameter: 25 cm

Vinyl bag dimensions:

• Length: 57 cm

Measure from your heel to the end of your cast, bandage, or prosthesis and add 4 cm to get the optimal SealProtect ® length.

Please pay attention to the maximum circumference allowed, including any bandage, cast, or support.

Instructions for Use:

1. Hold the plastic ring and stretch it to create a wide opening. Slide SealProtect ® as far up as possible. Avoid pressing directly on the ring while putting it on.
2. Make sure SealProtect ® fits at least 3 cm above your cast, bandage, splint, or similar for maximum protection.
3. Slightly push the plastic ring downward so the silicone membrane faces upward, as demonstrated in the final image.

Always dry both the ring and rubber membrane before removing SealProtect ®, as water may collect inside the ring where the membrane attaches.

Safety:

• SealProtect ® may be slippery when wet.
• Use SealProtect ® with care.
• Children should use SealProtect ® only under adult supervision.
• Dry with a towel only.
• Do not dry SealProtect ® on a radiator or heater.